F link jablotron version 4.06/11/2023 Close the cover of the detector with the installed module. Press the tamper contact in the detector (or briefly connect the blue and black module wires together) – the module is thusenrolled and the yellow LED indicator goes off.ĥ. Many downloads like Autodesk Ecotect Analysis 2011 may also include a crack, serial number, unlock code, cd key or keygen (key generator. Download Ecotect Analysis 2011 Full Crack. Go to the F-Link program, select the required position in the Detectors window and launch the enrollment mode by clicking on Enroll option.Ĭ. V-Ray 1.9 for Cinema 4D R12-R17 Win/Mac 32-64 bit Win Mac 317 MB. When the device is switched on, the yellow LED (3) starts flashing repeatedly to indicate that the module has not beenenrolled into the system.ī. Proceed according to the control panel installation manual. Jablotron JA-111H Bus module for the connection of a detectorFigure:ġ – bus terminal board 2 – production code 3 – yellow fault indicator 4 – red indicator is used to indicate activation of alarm or tamper input with a flashĤ. Go to the F-Link software, select the required position in the. Connect the wires to the detector (according to Fig. Install the module at a suitable place in the detector.>Ģ. The module has a status reaction (reports its activation and deactivation). Please have a look at the Release Notes for Flink 1.14 if you plan to upgrade your Flink setup from a previous version. JA-111H is a module that enables you to connect any wire from the sensor to the system BUS.
0 Comments
Leave a Reply. |